PLUG - SHRED - MOVE Connect the shredding machine to the power supply. From that point the shredding process is driven by the energy- and cost-efficient UNTHA Eco Drive. CUTTING CONCEPTS Depending on the material and fraction size two different cutting concepts are available: The ripper system, as well as the cutter system with internal pusher. The rotors are protected from wear by welded-on Hardox plates. With both cutting systems, fraction sizes of 400 mm to 30 mm are possible. Depending on the material property and screen diameter, the throughput performance is up to 70 t/h. When switching locations, the machine must be disconnected from the power supply. Thanks to the crawler-type undercarriage which is propelled by a small petrol-powered engine, the XR mobil-e can be easily moved to any spot via remote control. CUTTER-SYSTEM >> Indexable cutters that can be used four times >> Stator bars that can be used four times RIPPER-SYSTEM As soon as the desired position has been reached the machine can be plugged back into the power supply and will continue to shred efficiently and cost-effectively. >> Ripper teeth that can be used twice >> Stator teeth that can be used once The ripper and stator teeth can be welded on the outside of the machine after the end of the service life. 3